Pacific C-PRO G1/4 PETG Tube 16mm OD Compression – Blue Pacific C-PRO G1/4 PETG Tube 16mm OD Compression – Blue Pacific C-PRO G1/4 PETG Tube 16mm OD Compression – Blue Pacific C-PRO G1/4 PETG Tube 16mm OD Compression – Blue
Pacific C-PRO G1/4 PETG Tube 16mm OD Compression – Blue

Pacific C-PRO G1/4 PETG Tube 16mm OD Compression – Blue

In stock
P/N
CL-W210-CU00BU-A
USD$9.99
Thermaltake Pacific M-Pro PETG Fittings Installation Guide

Step 1. Slide the compression nut over the tube
Step 2. Install the o-ring
Step 3. Install the packing
Step 4. Install the fitting base on your components
Step 5. Tighten the compression nut

Caution: The O-ring and the packing with a groove on the inside diameter must always be installed towards the top of the compression nut.

Cautions

Thermaltake recommends the following steps before using the Pacific series radiators and water blocks:

  • To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
  • Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
  • It is strongly recommended to use market-proven pre-mix coolant, such as Thermaltake Coolant 1000, for optimal performance and corrosion protection.
  • Before storing your water cooling components, clean, rinse, and dry them to ensure a longer lifespan.

After completing your water loop setup, Thermaltake recommends:

  • Use pre-mix coolant, such as Thermaltake Coolant 1000, for corrosion protection and performance.
  • Fill the reservoir with coolant and power the pump on and off multiple times to ensure the loop is properly filled.
  • DO NOT let the pump run dry. Turn off the power immediately if there is no liquid entering the pump.
  • Fill the reservoir to the top to prevent air from entering the pump.
  • If necessary, tilt the system to help bleed air from the loop.
  • Place paper towels under fittings to test for leaks.
  • Run the loop with the fill port open for about 24 hours to bleed air out completely.
  • Flush the system correctly before starting to prevent any particles from sticking to your tubes and components.
  • Coolant color might fade over time.
More Information
P/N CL-W210-CU00BU-A
Model Pacific C-Pro G1/4 PETG 16mm OD 6 Pack - Blue
Dimensions D26 x 21 (H) (mm)
Weight 30 g
Material CU + AL
Note PETG Tube to G1/4
Applicable OD : 16 mm
Screw Thread G 1/4